Hellwig Air 6299 Instrukcja Użytkownika

INSTALLATION INSTRUCTIONS6299Air Suspension Kit (pat. pending)2009+ Dodge 1500 Pickup with Rear Coil SpringsThank you for purchasing a quality Hellwig

10. Attach leveling valve to bracket as shown using 1/4” nylon locknuts andwashers. Tighten to 7 ft-lb. Attach leveling valve linkage pins to valve an

11. IMPORTANT– BEFORE DRILLING ANY MOUNTING HOLES INCROSSMEMBER, remove jack stands and lower frame so that the weight of thevehicle is on the bump st

13. When satisfied with position of level-ing valve and linkage has been checked forproper operation and clearance, mark holelocation to attach leveli

559-734-7451 800-367-5480 FAX 559-734-7460Part C Compressor Installation14. Prepare the compressor for mounting by HAND-TIGHTENING the air filterinto

559-734-7451 800-367-5480 FAX 559-734-746016. Mount compressor to mounting plateusing fasteners supplied with compressoras shown in photo. Connect com

559-734-7451 800-367-5480 FAX 559-734-7460Plumbing and Wiring Diagram6299 ( R-6299) 02/26/2010

559-734-7451 800-367-5480 FAX 559-734-746018. Connect air springs to leveling valve as shown. Tie strap hoses as required to avoid con-tact with exhau

559-734-7451 800-367-5480 FAX 559-734-746028. After all connections have been verified, install fuse in inline fuse holder, apply parkbrake and start

BEFORE STARTINGYOUR PROJECTWHEN LIFTING A VEHICLE WITH A JACK, BE SURE TO SET THE PARKING BRAKE AND USE SAFETY STANDS.ENSURE THAT THE INSTALLATION OF

PartA Air Spring Installation1. Prepare vehicle for installation by chocking front tires and setting emergencybrake. Before starting installation, mea

3. Place retaining plate on top of rail as shown. Locate frame bracket on coilspring seat as shown with the notch pointing outboard. Insert 1/2 x 2-1/

4. Assemble air spring to axle bracket as shown. Make sure to orient axle bracket so that thenotch will clear brackets welded to axle assembly. Instal

5. Install air spring assembly on axle as shown. Insert studs in air spring through holes inframe bracket and attach air spring using 3/8” fine thread

6. Check installation that all bolts are torqued properly and that there is not interference withbrake lines or cables, electrical wires, fuel lines,

559-734-7451 800-367-5480 FAX 559-734-74607. Reference the ride height from step (1) and subtract 1” from this measurement. Adjustframe height to the

559-734-7451 800-367-5480 FAX 559-734-74609. Prepare leveling valve for installation. The inlet and exhaust ports have ascreen across the base of the